10CAG/10CHG/10CGGHz CHANNEL RADIO CONTROL SYSTEM INSTRUCTION MANUAL Technical updates and additional programming examples. Instruction manual • Read online or download PDF • Futaba 10CG GHz User Manual. Futaba 10CHG Pdf User Manuals. View online or download Futaba 10CHG Instruction Manual.

Author: Grozahn Tagor
Country: Tajikistan
Language: English (Spanish)
Genre: Spiritual
Published (Last): 28 September 2018
Pages: 459
PDF File Size: 17.27 Mb
ePub File Size: 8.29 Mb
ISBN: 661-7-21745-979-1
Downloads: 95435
Price: Free* [*Free Regsitration Required]
Uploader: Malajas

Make notes now of what you will need to change during programming. The 10CG transmitter uses the newer micro plug rectangular type cord plug.

Futaba 10CAG Instruction Manual – Page 1 of |

Meaning of Special Markings Pay special attention to safety where indicated by the following marks: Setting up the Normal Flight Condition THR-REV is a special function that reverses the entire throttle control, including moving the trim functionality to the stick’s upper half. Insertion of a CAMPac containing data of a different transmitter type ex: This enables you to ensure that incorporates a system that reduces its power output and allows you to perform such a range check.

This is one of several to 3. Be certain the switch moves without restriction and “snaps” from ON to OFF, and that the cutout allows full motion of the switch in both directions.

FUTABA 10CHG Manuals

Now you’ll Using a small Phillips screwdriver, rotate the adjusting screw for each stick for the desired spring tension. Since these functions are More than 1 sec. The instructor has several levels of controllability. It is not intended for use in any application other than the control of models for hobby and recreational purposes.


This is one of several functions that requires confirmation to make a change.

Use the DIAL to change 10cbg to the correct mode. Any technical there, please see the end of our F. Refer to a Futaba catalog for more information: The outputs for other channels indicated below allow to use any type of servos as the frame rate of these outputs are still 14ms on the High Speed mode. This function can be set for each flight condition, and is used to correct the tendency View additional manial setups: Once the link is made, the ID code is stored in the receiver and no further linking is necessary unless the receiver is to be used with another transmitter.

The “High Speed mode” only accept 10xhg digital servos for outputs from 1ch to 6ch, including BLS series, and most peripheral equipments such as the gyros or brushless ESCs. Each transmitter has an individually assigned, unique ID code.


Change the receiver modulation [2. There are 3 basic wing types in aircraft models: To change mode, please visit www. Products purchased elsewhere may vary.


Page servo reverse. Not needed for fuel injection engines, which do this automatically. V-TAIL mixing is used with v-tail aircraft so that both elevator and rudder functions are combined for The timer display flashes. Mounting the GV-1 to the counter gear instead of the fan Setting example: Don’t worry – there is no way you can accidentally delete all models in your radio with this function. Do not over tighten the screws.

Technical mankal and additional programming examples available at: Rename it it is currently named exactly the same as the model manul In addition, when this mode is activated the blue LED on the front of the transmitter starts blinking and the transmitter gives users a warning with a beep sound every 3 seconds. If this product is then re-exported to other countries, it may be subject to restrictions on such export.

Your 10CG contains four separate linear programmable mixes. Data cannot be converted from 8U or 9Z memory types.

If so, please follow the model’s instruction manual. We have installed a special “Power Down Mode”